LTP Ironwax Gloss - 1 litre

£10.99 (£13.19 incl VAT)
  • Product Code LTPC57
  • EAN Code 5031220005013
  • JAN Code LTP

Ironwax Gloss is a tough ionised acrylic gloss sealer that has been specially formulated to minimise maintenance of quarry tiles, terracotta, brick, slate, stone, terrazzo, unpolished marble and cement floors. 

LTP Ironwax Gloss is easy to apply, low maintenance self-shine gloss finish acrylic sealer. This product enhances colour and texture and protects against staining and stubborn dirt.  This Sealer may be used on travertine, limestone, sandstone, slate, un-polished marble, terracotta, quarry, bricks, terrazzo and concrete Suitable for domestic and commercial use. It is suitable for Interior use only

To use LTP Ironwax Gloss, always ensure surface to be treated is completely clean, dry and free from cement and grout stain. Any moisture may cause the LTP Ironwax Gloss to dry opaque or prevent the seal from reaching full hardness. Using a sponge or soft fluff-free cloth, apply a thin coat of LTP Ironwax Gloss evenly in one direction. Do not rub or buff the surface but allow to dry (approx 1 hour). Apply a second coat at right angles to the first. Subsequent coats should be applied at right angles to the previous. Do not over apply as too many coats may cause unsightly build up and/or reduce the efficiency of the product. Hardens after about an hour but will take a further three days to achieve full hardness and become fully water resistant. If in doubt, experiment on spare tiles to establish the optimum number of coats before general use.

This product is suitable for interior use only (not wetrooms or shower enclosures).

Coverage: Approximately 15-30m2 per litre (one coat) depending on substrate porosity.

1 unit = 1 x 1 litre bottle

Write Review